STOP Glass & Aluminium Protective Tape and Film from coming loose
The Problem: Loose Ends
Protective film and tape often come loose when the ends and edges are not perfectly sealed. These loose ends act as entry points for the elements, contributing to the tape and film coming loose and ultimately compromising the protection.
The Simple Two-Step Solution
Step 1 : Use a Squeegee
To Apply Protective Film to Glass
Use a squeegee to evenly apply the film across the entire glass surface. This ensures a smooth, bubble-free application and a perfect seal right to the edges.
Step 2: Use a Cloth
To Apply Protective Tape to Aluminium
Pro Tip: Avoid Overlapping
Try not to overlap the film as it sticks much better to the glass surface itself than it does to another layer of film.
Pro Tip: Secure Edges
Make sure the edges and corners of the tape & film are stuck down properly to prevent them from coming loose over time.
Surface Prep
Ensure the surface is completely **dust-free and dry** before application. Where possible apply in doors. This is crucial for proper adhesion.
Clean Hands
Avoid touching the adhesive side of the film and tape. If a section is touched, cut it off and use a fresh piece to ensure the glue remains effective.
Pro Tip: Cut, Don’t Snap
When applying tape to frames, use a sharp blade or scissors to cut it. Avoid stretching and snapping the tape, as this can affect the seal.
The Result: A Perfect Finish
This method ensures a smooth, even application that eliminates loose ends, which are the main cause of film and tape failure. Your products remain perfectly protected.
Need On-Site Help?
Contact Us : sales@dewpointindustries.com or call us on (021) 555 4334